FS (VIC) Custom made wheels, rear disc brake setup, camber compensator

[brendo_83]

As some of you will no doubt be aware I was forced to part with my reek late last year I've still got a few bits and pieces lying around that I need to get rid of.

Custom made Neale wheels that were on it when I bought the car, they have obviously been quite neglected so will need some work to get them looking reasonable again. They are VW 4 stud pattern and fill the guards out nicely. Tires are basically brand new, but are quite old so not sure if they'd actually be any good. From memory they are 15x8 fronts with Goodyear Eagle 235x55x15 and 15x10 rears with BF Goodrich 265x50x15. Missing most of the wheel bolts.





Also have the rear disc brake setup, VW discs and Subaru calipers (So I was told) working fine when removed from the car, pads are almost new, just needs custom length handbrake inner cables to be a complete bolt on kit.



And finally the camber compensator kit for swingaxle box, brand new.

No prices in mind, just make an offer.

I'm in clayton South Vic and can be contacted by phone (0407180908) or email (bajcampbell@hotmail.com)

Cheers,

Brenden

[The Metalsmith]

Hi Brendan,
                   I've liked those wheels since I first saw them years ago. Are they a 2 or 3 piece? They need to be separated to be restored. If not, it's all over for them. Call me and wheel discuss! 

     Simon
     0417 997 908

[Agroeureka]

Hi
 15x10 seems a little small for you from my recall

Andrew

[bazza]

ill offer 200 for wheels as i really need someting to make car roll

[brendo_83]

Hi all, wheels were picked up this morning...Sorry Simon I missed your post Pretty sure they are 3 piece, new owner is confident they are salvageable. Brakes and camber compensator still available.

[radekp81]

Apologies Simon, I shot off an email as soon as the listing went up, the wheels seemed too good to pass up. They are 3 piece and have lots of surface rust on the inner rims and some surface rust on the outers, damaging the chrome plating, though checking it on site it was just superficial with only light pitting of the surface in areas. I spent 7 hours yesterday with a wire wheel and sandpaper on them and I'm really happy with the way they are coming along. I'll post up a pic of the most progressed wheel soon. Still anther day or two to go on them.

[The Metalsmith]

No worries Rad and Brendo,
                                         You gotta be quick on this site! It's a shame Neale Wheels don't make this sort of wheel anymore. I rang them recently and they were saying they've never made wheels with a VW stud pattern. Go figure...

     Simon

[Rat Reek]

Hi Brendon,

do you still have the brakes
 

cheers Bruce

[brendo_83]

Hi Brendon,

do you still have the brakes
 

cheers Bruce

Yep